Description
A special product from the Lithofin range for marble, natural and concrete stone (MN). Lithofin MN Concrete Coating is a solvent-free, water-dilutable dispersion based on weather-resistant acrylics and hard wax. The product is ready to use and specially developed for professional use.
Properties
Lithofin MN Concrete Coating forms a weather-resistant surface film with slight colour enhancement. This facilitates cleaning and maintenance and reduces sensitivity to staining. Heavy soiling of tiles during installation, as well as the penetration of sand, cement, and soil, is prevented by Lithofin MN Concrete Coating. By filling pores, the adhesion of organic growth is impeded, which significantly reduces green staining of the tiles. Despite reduced vapour permeability, rising moisture can still evaporate through the surface treatment.
Note: a glossy film may form if overdosed.
Application
For treatment during production or post-installation of rough concrete tiles as protection during installation. Also used to enhance the appearance of rough concrete tiles. For indoor and outdoor use. Only limited suitability for finely ground surfaces, as it may increase slipperiness.
Directions for Use
The tile must be clean and free of stains. A well-dried substrate is recommended. Apply Lithofin MN Concrete Coating evenly over the surface using a sponge, lambswool applicator, or similar tool. Repeat the application on highly absorbent surfaces if necessary. The surface is not walkable during drying. Application temperature: not below 15°C and not above 25°C.
Drying time: Walkable after approx. 3 hours. The formed surface film should not be exposed to moisture or soiling for 24–48 hours.
Coverage: Up to approx. 15 m²/L, depending on surface porosity.